Used Extrusion line for PE/PP pipes: COLLIN E30P of 2008

Data Sheet of Used COLLIN E30P

Ref.: 300043355

Brand: COLLIN

Year: 2008

Other Specifications:

Laboratory equipment including an extruder and two downstream units for the production of tubes/films and sheets.

Extruder E30 P x25D
Made of nitrided steel, with an SCD microprocessor and a liquid crystal screen.
Temperature: Max. 300 ° C +/- 3 ° C
Screw speed: 2 - 160 rpm
Torque: 500 Nm
Max. Throughput: 15 kg / h
Feed hopper volume: 19 L
Heating zones: 4 x 1200 W
Cooling zones: 3x fan
Feed zone: only water-cooled
Drive: 8.8 kW
Electricity connection: 3x 380V / 50 Hz, L1, L2, L3, N
Total connection: approx. 15 kW
Water consumption: 5 - 10 l / min
Dimensions: 1750 x500 mm
Screws in nitriding steel:
Screw 30mm x 25D for PP / PP with the addition of PE
Screw 30mm x 25D for PVC
Screw 30mm x 25D for PA
Screw 30mm x 25D for PC, ABS, PC + ABS

Tubes production downstream:

Head for pipes d2-d25 mm, type Spider
2x heating zones
1 set mandrel/matrix for diametr 25 mm, thickness 3 mm
Additional set mandrel/matrix for diametr D15 mm, thickness 2 mm
Additional set mandrel/matrix for diametr D5 mm, thickness 1 mm

Vacuum calibration tank with cooling bath for pipes up to 25 mm
Tooling 5,15,25 mm

Haul-off unit, type RA500
Length: 500 mm
Max. tube diameter: 30 mm
Take-off speed: 0.5 - 5 m / min

Winder for tubes up d 5mm
Coil diametr: up to 600 mm
Coil width: 300 mm
For soft materials

Sheet and film production downstream:

Included slot die for film and sheet production on a separate frame
Width: 250 mm, with 3 heating zones
Gap: 0.3-1.5 mm

Included slot die for CastFilm on a separate frame
Width: 250 mm
Gap: 0.3-1.5 mm

Calender, type CR 135/350 S
Edge trimmer for soft material film edges up to 0.3 mm.
Winding unit for edge section
Water temperature control (up to 150 ° C, 6 kW heating, 23 kW cooling capacity)

3-section, mechanically extendable, winding cone (contact winding).

Spare parts included.

Line's operating hours: approx. 3100 h in total.