Used Extrusion lines for monofilaments: COLLIN E 20 P of 2008

Data Sheet of Used COLLIN E 20 P

Ref.: 300043362

Brand: COLLIN

Year: 2008

Other Specifications:

Equipment designed to produce blown film (blow film extrusion) or monofilament from polymer pellets, depending on the type of dies / auxiliary tooling used.
A separate tooling - flow rheometer allows the viscosity of the flowing polymer melt to be determined.

Consists of:
1. COLLIN E 20 P extruder
Serial number: 3200-23-08
Screw diameter: 20 mm, made of nitrided steel
L/D: 25
Screw speed: 2-180 rpm
Torque: 100 Nm
Maximum LDPE output: 3.5 kg/h
Hopper: 6 l
Cylinder heating zone: 3x1000 W
Cylinder cooling zone: 2 fans
Loading area with water cooling
Variable frequency AC servo motor

2. Bypass rheometer COLLIN WROR-III with melt pump (without extruder)
Simultaneous use of 3 capillaries
Variable pump speed: 1-30 rpm
Pump capacity: 0.66 cc/min.
Temperature sensors: PT 1000
Temperature range: 60 - 300°C

3. COLLIN TEACH-LINE monofilament line
Module A: Water bath
Module B: MDO-AT retention unit
Module C: Air-heated oven for monofilament extraction
Module D: Haul-off unit MDO-BT with single monofilament winder
Water thermostat
Monofilament die-head for 4 monofilament
Additional die-head for 4 monofilaments with a holes diameter of: 0,3 mm, 0,6 mm, 0,9 mm, 1,2 mm
Additional flat die-head

4. COLLIN TEACH-LINE blowing unit and hose head
(for sleeve film)
30 mm sleeve head with cooling ring
TEACH-LINE
Blowing unit TEACH-LINE BL 50 T
Sliding table 700x500 mm for BL 50 T

5. TEACH-LINE E 20 T extruder
Serial number: 9120-23-08
Hopper capacity: 3.2 l
Screw diameter: 20 mm
L/D: 25

Small number of working hours.

Lifting and turning ventilation unit for removing fume, dust, gases, aerosols and other harmful substances from a local emission source - 3 pcs.