Used Label sheeter - cross cutting: ABG OMEGA DIGICON SERIE 2 of 2008

Data Sheet of Used ABG OMEGA DIGICON SERIE 2

Ref.: 300045233

Brand: ABG

Year: 2008

Other Specifications:

Machine with working direction from right to left
Maximum material width 330mm

Equipment specifications and configuration:

Reel Feeder.
- For reels up to Ø700mm diameter, with expandable pneumatic shaft Ø76mm.
- Automatic tension control.
- Programmable stop and speed reduction when the preset size is reached.
- Automatic side material aligner, with ultrasonic sensor for edge guiding.
- Includes adjustable table for reel joining, with pneumatic clamps.
- Motorized reel elevator

Traction nip and dancer at the entrance (semi-rotary mode).
- Allows to separate the tension zones.

Semi-rotary hot foil stamping module.
- Equipped with magnetic cylinder and use of 0.71 mm thick Rotometric "Uniflex" type flexible engraving plates and 0.95 mm rubber including double-sided adhesive.
- Maximum / minimum feed: 457 mm (18") / 50 mm (2")
- Automatic longitudinal registration by means of photocell, with respect to the pre-printing of the reel.
- Foil feeder on 200 mm diameter reels and 25 mm pneumatic shaft.
- Oil heating equipment up to 200 ºC.
- Hydraulic and manually adjustable pressure introduction.

Flexographic unit
- Servo-driven flexographic printing unit (rotary and semi-rotary mode).
- Includes cassette complete with ink cup; pick-up roller; anilox and one cylinder for continuous varnishing and 19" (152Z) printing plate cylinder.
- Automatic longitudinal registration by means of photocell, with respect to the pre-printing of the web.
- Hot air dryer.
- GEW UV dryer of 140w/cm.

Laminating module.
- For use as:
o Laminating with adhesive film without backing.
o Laminating with adhesive film with backing
o Laminating with non-adhesive film, applying the glue on the flexo unit
o Calendering UV varnish avoiding "orange peel" effect, "high gloss" or "super varnish" type finishing
o Cold foil stamping ("cold foil")
- Film feeder and rewinder on 400 mm diameter reels and 76 mm pneumatic shaft.

Semi-rotary die cutting unit
- Includes 152z magnetic cylinder
- Includes servo motorized printed mark registration correction.
- Standard distance between die and pressure cylinders 480 microns.
- K&B Gap master

Traction nip and dancer at the exit (Semi-rotary mode).
- Allows to separate tension zones.

Scrap stripping unit
- Section for die waste stripping.
- Rewinder with Ø76mm pneumatic shaft and web breakage sensor.

Rewinding unit with double shaft in upper and lower position.
- Back-scorer slitting module with two knives for material regrinding.
- Slitting module equipped with 5 knives/counter knives for scissor type cutting.
o Lifting and separating of the blade and counter blade automatically at machine stop.
o Includes traction nip to maintain tension independent of rewind.
o Minimum distance of 15mm between blade and cutting blade.

General Specifications:
- Maximum material width: 330mm.
- Minimum material width: 180mm
- Min. repeat : 2" (50.8mm)
- Max repeat : 18" (457.2mm)
- Max. rewind diameter: 600mm (bottom)
- Meters, number of labels, batches and pause mode counter