Used Extrusion Blow Moulding machines up to 10L

Included: Blowmoulding machine (without moulds, blowpins) pin and die can be included Blender Grinder

Leak tester

PLC Gefran

Extrusion blow moulding machine UNILOY BWF 16 E - 2004: 1 Station for (current) 10L jerrycan EXTRUDER: screw diameter: 90mm L/D: 24 Speed: 76 rpm Brushless drivers: AC with inverter or DC Screw rating: 70 kW Output capacity: 220 kg/h (PE) Cushioned dry cycle: 2,4 sec. Max. Working cycles/hr per side: 600 Performance rating, oil pump motor: 22 kW Hydr. Operating pressure: 120bar Max. Hydr. High pressure 170-210 bar Operating pressure pneumatic: 8-10bar Pressure air requirement approx.: 2.500 Nl/min Hydraulic tank cooling: 55.670 kJ/h Blow mould: BW F16E: Max. mould length with adapter plates E: 520mm Max. mould length without adapter plates E: 435mm Max. mould width: 500/520 mm Min daylight between closed platens: 310mm Max. mold daylight (opening stroke): 320mm Max. daylight between opened platens: 640mm Clamping forces: 160/200* kN Horizontal shuttle stroke: 520/540*mm In 2019 the system was completely overhauled, new Beckhoff control system etc. pp. Only 5500 h run since then. Included is a quality centre for weight, tightness and neck as well as a packing table for up to 60 canisters.

Reciprocating screw blow molding machine 900g maximum shot size 50 tons clamp force Rotary toggle clamp actuator Trimming unit Resin vacuum unit (Conair Dustbeat) Bottle take out device included Power Unit 75 HP electric motor, 230/460 volt, 3-phase, 60 Hz., 60 GPM hydraulic pump, 150 gallon reservoir 15-20 tons chiller water required, molds and machine 40 CFM @ 100 PSI compressed air required