Used Thermoformer: ILLIG RDKP 54D of 1998

Data Sheet of Used ILLIG RDKP 54D

Ref.: 300040634

Brand: ILLIG

Year: 1998

Other Specifications:

3 Stations: Forming - Cutting - Stacking
Min. forming dimensions: 196x200mm
Tool width between conveyor chains max : 600mm
Tool length in feed direction max : 400mm
Total tool length with cooling mold for PET processing: 570mm
Feed rate at PET processing max : 285mm
Width of material min-max : 200-630mm
Feed rate min-max: 200-400mm
Material reel diameter max : 1200mm
Vacuum pump power max : 100m3/h
Mould closing force max : 12000 daN
Speed (Motorized drive for forming station) max : 40 cycles/min
Speed (pneumatic drive for forming station) max : 35 cycles/min
Upper-lower heating: 20.5kW

Working hours : 26452
The machine is in good condition and has worked recently.
It has wear on the upper table (see photos) for the assembly and disassembly of the tools.
As for the defect, it only affects the installation and disassembly of the tooling; it does not affect the operation of the machine.
The tools are installed with brass T, so it is necessary to accompany the tool during installation to prevent the T from passing through the hole when it is installed.
But as soon as it's in position, tighten the tool and it's OK.
The best would be to make a repair or replace the upper table (the table costs approximately 8K€)

To obtain a thickness greater than 1mm, chain spacers must be added (the seller worked with a thickness of 1.8mm)